Skip to main content

Sensor and Trap Cleaning

Air flows continuously through the sensor, so dust and pollen can build up on the surfaces of the flight tube and reduce the sensor's sensitivity. Dust and debris on the funnel net and catch bag can also reduce air flow and sensor accuracy. Follow this procedure to keep the trap working properly.

tip

Clean the flight tube, funnel net and catch bag at least every 3 months. Clean them more often in dusty environments.

Watch the Sensor Cleaning Procedure

Preparation & Requirements​

  • Cleaning fluid: A compatible cleaning fluid (see Approved Cleaning Fluids) in a spray bottle with an adjustable nozzle. Set the nozzle to a jet to remove stubborn dirt.
  • Light source: Good light or a torch, so you can see each face of the flight tube clearly.
  • Clean dry cloth: For drying the inside of the sun hat and the inlet piece.
  • Warm water: For rinsing the funnel net and catch bag.
warning

Do NOT use any of the following on the flight tube. They can cause crazing or clouding of the acrylic:

  • Domestic glass cleaners or multi-purpose cleaning solutions containing alcohol, ammonia, ketones, aromatics, esters or halogens.
  • Solvents such as acetone, benzene, gasoline, carbon tetrachloride or thinners.
  • Kitchen scouring compounds.

Approved Cleaning Fluids​

Use one of the following solutions in a spray bottle with an adjustable nozzle:

SolutionPreparation
Soapy waterAdd 1 teaspoon of washing-up liquid (Fairy, etc.) to 1 litre of clean water.
Acrylic/plexiglass window cleanerFor example: Ambiti Acrylic cleaner, Nigrin caravan acrylic windscreen cleaner, S-Polybond acrylic and plexiglass cleaner. Follow the manufacturer's instructions in each case.

Flight Tube Cleaning​

Phase A: Preparing the Sensor​

  1. Disconnect the power: Disconnect the power supply from the sensor.
  2. Turn the sensor upside down: Remove the sensor from the trap, turn it upside down and rest it on the sun hat (see Fig1).

Phase B: Cleaning the Flight Tube​

  1. Inspect the flight tube: In good light, or using a torch, look at each face of the flight tube.
  2. Spray the faces: Spray jets of a compatible cleaning fluid onto each face of the flight tube to remove the dust. Keep looking at each face while you spray, until it is clean.

Fig1 - Sensor upside down on the sun hat while cleaning the flight tube

Phase C: Draining and Drying​

  1. Drain the excess fluid: Tilt and hold the sensor to drain the excess cleaning fluid from the sun hat (see Fig2).
  2. Pat dry: Use a clean dry cloth to pat dry the inside of the sun hat and the inlet piece.

Fig2 - Tilting the sensor to drain the cleaning fluid

Phase D: Reinstallation​

  1. Re-fit the sensor: Put the sensor back on the trap.
  2. Apply power: Connect the power supply. The fan dries the flight tube, which prevents marks caused by slow-drying soap bubbles.
info

Apply power straight after cleaning. If the flight tube dries slowly without the fan, soap bubbles can leave marks on its surface.


Funnel Net and Catch Bag Cleaning​

  1. Remove the funnel net and catch bag from the trap.
  2. Rinse them with warm water to remove dust and debris.
  3. Let them dry, then fit them back on the trap.

Maintenance Schedule​

ComponentFrequencyMethod
Flight tubeEvery 3 months (more often in dusty environments)Spray with a compatible cleaning fluid, drain, pat dry, power on.
Funnel netAt least every 3 monthsRinse with warm water.
Catch bagAt least every 3 monthsRinse with warm water.